Seb's Synth-DIY Pages

JoyKontrol - Stripboard layout


Click to view printable version of this page



The BOOSTER sub-circuits (Q1, Q2, Q3, R55, R56, R57 on top right of the board) were a last minute addition so they are rather squeezed on.  The left sides of R55, R56, R57 need to be soldered directly to the wire connections rather than into the board.

Note that the LED jumper pin numbers on the schematic do not correspond to the pin numbers of the LED unit itself - this was done to make the routing on the stripboard easier.  However I have labelled the jumper pins correctly on the layout image above - the numbers on the image correspond to the actual pin numbers of the LED unit itself.

To use as a guide when breaking the stripboard tracks, save and print this TIFF file.  This is an actual size view of the tracks from the copper strip side, and can be used as follows:


Here's the stripboard marked and with some of the tracks broken:




More ..